Quadrax
- Entering Bootloader
- Update Instructions
- Changelog
- Turn off power to your modular system.
- Connect a USB cable from the rear of the module to your computer.
- Hold down the top left CV A button and top right RISE button and turn on power to your modular system.
- From the version menu above, select the firmware version you will be updating to.
- Click the Update button in the bottom of this window. You will see the progress of the update in the
log window and your module may begin to flash. You will see an “Update completed successfully” message at
the end of the update.
- Turn your modular off and back on again, you're now ready to use your updated module.
- If there are any problems please contact us via the Help button on our website. Be sure to include the full
log window output, the firmware updater version downloaded, and the OS you are using.
1.3.0.0 (2021-10-05)
- NEW: Utility UI Mode (Hold RISE + LEVEL for 1 Second to Toggle). The left buttons will manually trigger a
channel; the right buttons will set (5 or 10V) and attenuate (20% Increments) the channel's output level.
- REMOVED: 10V/5V Envelope size global toggle. Replaced with per-channel setting in Utility Mode.
- FIXED: Phase/Clock Sync abnormalities in LFV Mode.
- Updated manual available at intellijel.com/support.
1.2.1 (2021-03-09)
- CHANGE: Envelopes are linked via gates, not trigs. Allows triggering of AHR envelopes by linking to a previous
envelope.
- CHANGE: Reduced size of pot dead zone.
- FIXED: Slightly longer minimum attack and decay times. Fixes modulation of some waveform types when at minimum.
- FIXED: LFOs not clock syncing in some cases.
1.2.0 (2020-11-19)
- NEW: Phase sync for clock-synced LFOs. See manual for details.
- CHANGE: Various optimizations, reduced latency.
- CHANGE: Sharper minimum attack and decay times.
- CHANGE: Add 5% dead zone at end of pot travel to account for component tolerances.
- CHANGE: Remove crossfade at the extreme ends of one-shot mode 1.
Instead the waveform just switches from square to sine.
- FIXED: Fixed initial phase of one-shot mode square waveforms.
- FIXED: Improved trigger detection.
1.1.3 (2020-03-03)
- FIXED: Some settings may not have carried over correctly when the firmware was upgraded from 1.0.2 or earlier.
1.1.2 (2020-02-25)
- FIXED: Edge case where CV assignments are not being applied.
- NEW: Long press LEVEL button when in System Mode to reset module's settings to defaults.
1.1.0 (2020-02-06)
- NEW: Replaced original burst mode.
- NEW: Alternate modes for each mode.
- AR/ASR/Cycling AR: Mirrored Rise/Fall Curves.
- Burst: Tilting saw shape instead of sine/square crossfade.
- LFO: Low Frequency Vacillator — Drifting chaotic voltage source.
- CHANGE: More extreme log/expo curves.
- CHANGE: 10V is the new default Envelope size.
- NEW: System Mode for system toggles like envelope size.
- FIXED: Distorted expo/log curves.
1.0.2 (2019-12-19)
- FIXED: Added toggle for dithering to remove "quantize error noise" from outputs.
1.0.1